Hi,
I am using Pic Basic Proc 2.41 to write my basic programs and when I use the LCDOUT command on a 4 line LCD display I seem to be unable to drive and light up the middle row of pixel on the third line of the display. Everything else is fine. I have tried numerous displays and they all do the same thing. Has anyone experienced the same problem and if so where can I get a fix for this.
Regards
Ivan
From:
Sent: Friday, 16 November 2007 3:24 AM
To:
Subject: Re: [piclist] Savining a Hex file in MPLAB
At 10:53 PM 11/14/2007, kg4pid wrote:
>Does anyone know how to use MPLAB to read the hex code out of a non
>code protected pic chip and then to save that to a hex file.
>Under "Programmer" there is a "Read" command but I don't see any way
>to save it or even display to data that was read. I've gone thru the
>help and doen't see anything.
Make sure that you have the "Program Memory" window visible /
enabled. You will find this under either the "View" or "Window"
captions at the top of MPLAB (depends on which version of MPLAB you are using).
You should also have the option of displaying disassembled code as
well. I **think** you might have to right-click on the Program
Memory window to see that option. Again, depends on which version of
MPLAB you are using.
Hope this helps.
dwayne
--
Dwayne Reid <dwayner@planet.
Trinity Electronics Systems Ltd
(780) 489-3199 voice (780) 487-6397 fax
www.trinity-
Custom Electronics Design and Manufacturing
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch format to Traditional
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___
No comments:
Post a Comment