I had a similar problem when i first used serial communication.
Every code i tried,(even the tested ones i got from others from the group) nothing would be transferred.
It was solved when, i changed the config word.The crystal settings were initially set to HS.(datasheet specifies >8Mz as HS).I changed this to XT.Everything woked fine after that.
This is the link to that discussion :
http://www.electro-
Hope taht hepls.
to unsubscribe, go to http://www.yahoogroups.com and follow the instructions
MARKETPLACE
Earn your degree in as few as 2 years - Advance your career with an AS, BS, MS degree - College-Finder.net.
Fed Lowers Rates Again - Think you pay you much for your mortgage? No SSN Required - Estimate New Payment.
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch format to Traditional
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
.
__,_._,___
No comments:
Post a Comment